Method of Statement Self Leveling by Arifeen marble

Method of Statement for Self-Leveling

1. Introduction

This method of statement outlines the procedures and steps required for the successful application of self-leveling compounds. This ensures a smooth, durable, and level surface suitable for various floor coverings.

2. Scope of Work

The scope includes surface preparation, application of the self-leveling compound, and finishing procedures. This method applies to both residential and commercial flooring projects.

3. Materials and Equipment

• Self-leveling compound
• Primer
• Mixing tools (drill with mixing paddle)
• Spiked roller
• Trowel or squeegee
• Protective equipment (gloves, goggles, etc.)
• Cleaning supplies (vacuum, broom, etc.)

4. Surface Preparation

4.1. Inspection and Cleaning

• Inspect the substrate for any cracks, holes, or uneven areas.
• Remove any loose debris, dust, grease, or oil using a vacuum or broom.
• Ensure the surface is dry and free from contaminants that could affect adhesion.

4.2. Repairing

• Repair any significant cracks or holes using an appropriate patching material.
• Allow the repairs to cure according to the manufacturer’s recommendations.

4.3. Priming

• Apply a suitable primer to the substrate to enhance the bond between the self-leveling compound and the surface.
• Follow the manufacturer’s instructions for mixing and applying the primer.
• Allow the primer to dry completely before proceeding with the self-leveling compound application.

5. Mixing the Self-Leveling Compound

• Refer to the manufacturer’s instructions for the correct mixing ratio of the self-leveling compound and water.
• Pour the required amount of water into a clean mixing container.
• Gradually add the self-leveling compound to the water while continuously mixing with a drill and paddle mixer.
• Mix until a lump-free, homogeneous mixture is achieved.
• Allow the mixture to sit for a few minutes and then mix again before application.

6. Application of Self-Leveling Compound

6.1. Pouring

• Pour the mixed self-leveling compound onto the prepared and primed substrate.
• Start pouring from one corner and work your way towards the exit, ensuring an even spread.

6.2. Spreading and Leveling

• Use a trowel or squeegee to spread the compound evenly across the surface.
• Apply the compound in sections, ensuring each section blends seamlessly with the next.
• Use a spiked roller to remove any air bubbles and ensure a smooth, level finish.

6.3. Curing

• Allow the self-leveling compound to cure according to the manufacturer’s guidelines.
• Avoid any foot traffic or additional work on the surface during the curing period.

7. Final Inspection and Finishing

7.1. Inspection

• Inspect the leveled surface for any imperfections or uneven areas.
• Make any necessary touch-ups while the compound is still workable.

7.2. Finishing

• Once the self-leveling compound is fully cured, the surface is ready for the installation of the final floor covering.
• Follow the specific installation guidelines for the chosen flooring material.

8. Safety and Environmental Considerations

8.1. Personal Protective Equipment (PPE)

• Wear appropriate PPE, including gloves, goggles, and protective clothing, to prevent skin and eye contact with the materials.

8.2. Ventilation

• Ensure adequate ventilation during the mixing and application process to avoid inhalation of dust and fumes.

8.3. Waste Disposal

• Dispose of any leftover materials and containers according to local regulations and environmental guidelines.